Trace Alchemy
Trace the image
Choose how edges become lines, and how closely the lines follow them.
The Trace tab turns the prepared picture into shapes. The tracer finds the borders between areas of colour, marks the corners along them, and fits smooth curves and straight lines between the corners. Each change traces the frame again; watch Trace: and Laser: in the status bar to see what it costs.
Outline or centre line
| Mode | What it traces | Use it for |
|---|---|---|
| Outline Mode | Around the edge of every area of colour. A drawn line is a long thin area, so the laser draws both sides of it. | Logos, solid shapes, text |
| Centerline Mode | Down the middle of thin strokes: one laser line for each drawn line. | Line drawings, handwriting, sketches |
Background
The background colour is left out of the trace. Auto finds it, which is right for most pictures. Choose White, Black or Custom (then pick the colour) when it guesses wrong, for example when the artwork fills most of the picture.
Areas traced keep their colour on the laser. Dark artwork on a white background therefore traces into dark, nearly invisible laser lines: use Invert Colors on the Media tab so the artwork becomes light on black.
Reduce colours
Every area of colour becomes its own shape, so a gradient or a photo can produce thousands. No reduction keeps every colour. Untick it and set Number of Colors to merge the picture into that many colours before tracing: 2 to 8 suits most logos and cartoons. Fewer colours mean fewer shapes, fewer points and a faster trace.
Edge Contrast
Edge Contrast ignores colour changes smaller than the setting, so gradients and soft shading merge into single areas and only clear borders are traced. At 0 every change is traced. Raise it for photos, skies and shaded artwork.
Corners and curves
These decide how closely the lines follow the picture. A close fit with many corners copies every pixel step and speck and costs points; a looser fit smooths the outline and simplifies it. Start from the defaults, change one setting at a time, and compare the counts in the status bar.
Under Curve Fitting:
| Control | What it does |
|---|---|
| Break threshold | How far, in pixels, a curve may stray from the edge before it is split in two. Higher: fewer, smoother curves. Lower: a closer fit and more points. |
| Pre-Fit smoothing passes | How many times the edge is smoothed before curves are fitted. More passes iron out pixel steps and noise; too many round off small details. |
| Spline / straight threshold | How far a curve may bend and still be drawn as a straight line. Higher: more straight lines, fewer points. |
| Line rev. threshold | Turns curves that are almost straight back into lines. Rarely needs changing. |
Under Corner Detection:
| Control | What it does |
|---|---|
| Angle threshold | How gentle a bend can be and still count as a corner. Higher: more bends become corners. Lower: only sharp bends do. |
| Corner threshold | Bends sharper than this always become corners, even right next to another corner. |
| Corner Pixels | How many pixels either side of a point are looked at to decide whether it's a corner. Higher: steadier corners on rough edges, but small corners are missed. |
| Tangent line pixels | How many pixels are used to judge which way an edge runs at a corner. Higher: smoother joins. |
| Remove Adjacent Corners | Merges corners that sit side by side into one. Cuts points on rough or jagged edges. |
Corners matter on the laser too: each one can get anchor points (see Anchors), so fewer traced corners also means fewer laser points.
Starting points
| Picture | Mode | Colours | Also |
|---|---|---|---|
| Logo in flat colours | Outline Mode | 2–8 | Edge Contrast at 0 |
| Line drawing or handwriting | Centerline Mode | 2 | Invert Colors if the lines are dark |
| Photo | Outline Mode | 4–12 | Edge Contrast high, Break threshold up, more despeckling |