Routing

Video DACs

Draw the laser picture on a display, Syphon or Spout.

A Video DAC shows a projector's laser output as a "laser look" video picture on a display, over Syphon (macOS) or Spout (Windows), or both. Use it for crowd-scanning looks from a video projector, or extra "lasers" on LED walls and media servers.

Before you start

  • Your licence must include Video DACs. Without it, the setting reads Video DACs (not in your licence). See Licence and account.
  • In Settings → General → Hardware, tick Video DACs and set Outputs (1–32, default 4): the number of Video DAC N rows a scan lists.

Set up a Video DAC

  1. On Routing → Projectors, add a projector for the picture (for example "Video wall").
  2. Click Scan. Video DAC 1, Video DAC 2 … appear with a video icon.
  3. Assign a Video DAC to the projector by hand (Auto-configure never assigns them).
  4. On the Zones tab, route a zone to the projector.
  5. Select the projector. Its settings end with a section named after the Video DAC; check Enabled.
  6. Click Displays… and pick a display, or tick Syphon / Spout.
  7. Arm the output and play something.

The picture gets everything a laser gets: zone geometry, mask, Power Map, cue and master effects, blackout, test patterns, global intensity, and the projector's Scan rate, X mirror, Y mirror and Swap X/Y. The scan rate sets the picture's brightness and timing, as on a real scanner.

Follow laser output (on by default) blacks the picture when the laser output is off. Turn it off for video-only rehearsals.

Assign a display

  1. Click Displays…. The Video DAC displays panel opens; the show keeps running.
  2. Click Identify if you aren't sure which display is which.
  3. Click a display card and pick the Video DAC, or pick a display from the Video DAC's row.

One display holds one window: a second Video DAC (or the timeline video) on it reads Display in use. Using the display the main window is on, or the timeline video's display, asks first.

The workspace remembers each Video DAC's display by the display itself, not its number. On another rig, a badge on Routing, a banner (N video output(s) need relinking) and a warning icon in the DACs table say so. The lasers are not affected.

Click Relink…, read each Video DAC's Was: … line, pick the right display, then save the workspace. A display unplugged mid-show relinks by itself when plugged back in.

Needs relinking means the stored display is not connected, or that there are several identical displays and you must pick one by hand. Not set up in the DACs table means no projector uses that Video DAC yet.

The laser video engine

The engine draws the pictures. It starts when an enabled, routed Video DAC has a display or sender, and stops when none does. If it stops, every Video DAC goes black; the lasers and timeline video keep running.

State What to do
Stopped The reason line says what is missing. Start forces it on
Restarting It stopped unexpectedly. Restart now skips the wait
Not licensed / Off Check your licence, or turn on Video DACs in Settings → General
Player not found / Wrong player / Can't start Reinstall or update Live Alchemy, then Restart now

Gotchas

  • Picture stays black: check Enabled, the zone routing, that the output is armed (or Follow laser output is off), that something plays, and that the engine is Running.
  • Escape in a fullscreen window makes it a normal window.
  • The .xroute routing export doesn't include Video DAC settings; the workspace does.
  • The picture runs slightly behind the lasers, more so with a slow video projector.
  • There is no corner pin or mask on the picture itself, and no NDI output (use a Syphon or Spout to NDI bridge). Shape the picture with the zone's geometry, mask and Power Map.